Size Guide

This guide will help you choose your ring or bracelet size correctly. If you print the document to choose your ring or bracelet size, please make sure that no scaling is done when printing.

Ring

It is preferable to measure your finger circumference at the end of the day. Avoid measuring when your finger is hot or cold.

Also, please note that finger measurements vary slightly from one hand to the next.

There are two ways to find your ring size:

1. Measure your finger circumference

2. Use one of your rings that fits your finger perfectly.

If you have a tape measure at your disposal, measure your finger circumference with it. Then compare your measurement in millimeters with the nearest measurement in the table below. This will help you find the right size for your ring.

If you don't have a tape measure, take a piece of wire or paper and wrap it around the base of your finger. Mark the point where the wire/paper closes the circle. On a flat surface, use a ruler to measure the length in millimetres between the beginning of the wire/paper and your mark.

Using the ring size chart, match your measurement in millimeters to the nearest in the table below.

Image

Choosing a ring size from an existing ring

If you have a ring that fits perfectly on the finger on which you will wear your Bäumer creation, you can use the ring sizer below.

Print out the size chart. Before printing, make sure there is no scaling when printing. Use a ruler to check that size 44 measures 14.01 mm.

Position your ring over the circles drawn, making sure that the inside of the ring is aligned with the circle that fits the best. This will help you find the right size for your ring.

If your ring fits between two sizes, it's best to choose the larger one. It's always possible to resize after purchase, if necessary.

Image

Maison Bäumer uses European sizes as a reference. Please consult the size chart above to find the equivalent size in your country.

Vous pouvez télécharger le fichier PDF du guide des tailles en cliquant sur ce lien :
Télécharger le PDF .

Image

BRACELET

There are two ways to find your bracelet size:

1. Measure your wrist size

2. Use one of your bracelets that fits well

When choosing your bracelet size, take into account whether you prefer to wear your bracelets tightly or comfortably. Adjust or remove centimetres as necessary.

Measure your wrist circumference to choose your bracelet size

If you have a tape measure at your disposal, wrap it around your wrist to measure the size of your bracelet. Match your measurement in centimeters to the nearest available size. This will help you find the right size for your bracelet.

If you don't have a tape measure, take a piece of wire or paper and wrap it around your wrist. Mark the point where the wire/paper closes the circle. On a flat surface, use a ruler to measure the length in centimetres between the beginning of the thread/paper and your mark. Match your centimeter measurement to the nearest available size. This will help you find the right size for your bracelet.

If you wish to measure your bracelet size with the “Bäumer wrist ruler”, please print out the following page. Before printing, make sure that no scaling is done during printing. Cut out the ruler and adjust it to your wrist to measure your bracelet size. Match your centimeter measurement to the nearest available centimeter in the size range. This will help you find the right size for your bracelet.

Use one of your bracelets that fits you well

If you have a bracelet that fits you perfectly, you can use it to find the bracelet size on which you will wear your Bäumer creation.

Image

Vous pouvez télécharger le fichier PDF du guide des tailles en cliquant sur ce lien :
Télécharger le PDF .